Power Foam is safe for fuel injectors, catalytic converters and emissions-control devices. It will not damage seals, gaskets, rubber or plastic materials commonly used in gasoline engines.

Performance Features

Applications

Directions

1. 1. Protect painted surfaces and mass airflow sensors (MAF) from spray.
2. 2. Ensure application is in a well-ventilated area.
3. 3. Run engine to normal operating temperature and remove air cleaner assembly.
4. 4. While engine is running, spray foam directly into throttle body as fast as possible without stalling engine. It is common to have to rev the engine above idle to facilitate this process.
5. 5. Shut off engine and allow to sit for 10-15 minutes.
6. 6. Replace air cleaner.
7. 7. Restart engine. Repeat application of Power Foam as needed.

In extreme cases, disassemble carburetor and soak parts.

Recommendations
Avoid contact with hoses and exterior plastic components. To prevent the dissolving of paint, do not overspray. Clean any overspray immediately to prevent unintentional component damage. AMSOIL Power Foam is not recommended for use in diesel engines or as a general-purpose degreaser.

AMSOIL PRODUCT AVAILABILITY
AMSOIL Power Foam is available in 18-ounce spray cans.

AMSOIL PRODUCT WARRANTY
AMSOIL products are backed by a Limited Liability Warranty. For complete information visit  www.amsoil.com/warranty.aspx.

HEALTH & SAFETY
This product is not expected to cause health concerns when used for the intended applications and according to the recommendations in the Safety Data Sheet (SDS). An SDS is available online at  www.amsoil.com or upon request at (715) 392-7101. Keep Out of Reach of Children. Recycle used oil and bottle.